Tampilkan postingan dengan label Drawing. Tampilkan semua postingan
Tampilkan postingan dengan label Drawing. Tampilkan semua postingan

Jumat, 22 Januari 2021

Gate Valve

  /   Tidak ada komentar   

 Gate valves are widely used in fluid control systems to control valve flow. General doors are designed to be fully open or closed. When the gate valve is fully opened, there is no obstruction in the flow path resulting in very low friction loss.






Download
Drawing
Size : 5068 KB

Ball Valve

  /   Tidak ada komentar   

 The ball valve is equipped with a spherical closure that can control the flow of air. The sphere has a port, also known as bore through the center. When the valve is in a boring position, it is in line with the pipe being open and the fluid can flow.



Download
Drawing
Size : 12704 KB

Butterfly Valve

  /   Tidak ada komentar   

 Butterfly valves operation is similar to the ball valve, which allows it to close quickly. Butterfly valves are generally preferred because they cost less than other valve designs and are lighter and therefore require less support. The disc is in the middle of the pipe. Axial through the disc to the actuator on the outside of the valve. Rotating the actuator causes the disc to be parallel or perpendicular to the flow. Unlike ball valves, the ball valve is always in the flow, thus causing the pressure to drop even when open.





Download
Drawing
Size : 492 KB

Thermowells ( Sensor PT.100)

  /   Tidak ada komentar   



             Thermowells are pipe fittings used to protect the temperature sensors installed in the industrial process. The thermowell consists of a closed conduit at one end and is mounted in the process stream. Temperature sensors, such as thermocouples or resistance thermometers, are inserted into the open ends of pipes, which are typically outside air, outside pipes or pipes, and insulated. The chemical process is transmitted through the heat to the walls of the Thermowell, which transfers the heat to the sensor. Due to the larger sensor set, the sensor responds to the change in operating temperature by adding a pond. If the sensor does not work, it can be replaced without draining the boat or pipe. Due to the increased temperature and due to heat wall, the heat from the sensor’s precision process and response is negatively affected by the increase in thermostat.

DOWNLOAD
Gambar
Size : 335 KB